ProjectingCheck the connections of the peripheral devices (Æpage36) and connection of the power cord (Æpage41) andpowering on the projector (Æpage42) to start the projector. Select the image and adjust the state of the image.Selecting the input signalSelect an input signal.1)Press , , or button on the remote control or button on the control panel.fThe image of the signal being input in the selected terminal is projected.fYou can check the input source through [DETAILED] / [SIMPLE] under the [DISPLAY OPTION] → [ON-SCREENDISPLAY] → [INPUT GUIDE] menu.fYou can also select the input source by pressingasqwon the [DETAILED] screen.AttentionfImages may not be projected properly depending on the connected device and DVD, video tape, etc. to be played. Set the[PICTURE] menu → [RGB/YCBCR] or [RGB/YPBPR]. (Æpage60)fCheck the aspect ratio of the screen and the image and select the optimum aspect ratio under the [POSITION] menu.(Æpage 69)How to adjust the state of the imageIf the projected image or the position is not correct when the positioning of the projector and the screen is correctly installed,adjust the focus and zoom.1)Adjust the projection angle.fInstall the projector on a flat surface and parallel to the screen so that the projected screen is rectangular.fIf the screen is tilted downward, extend the adjustable feet and adjust the projection screen so that the projected screenis rectangular.fFor details, see “Adjusting adjustable feet”. (Æpage 34)2)Adjust the lens shift.fAdjust the projection position with the vertical lens shift dial.fFor details, see “Adjusting the position using the vertical lens shift function”.(Æpage 34)3)Adjust the zoom and the focus.fRotate the zoom lever to zoom in and out the image.fRotate the focus lever to adjust the focus of the projected image.Focus leverZoom leverNotefIt is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.fIf you adjust the focus, you may need to adjust the size of the image by turning the zoom lever again.fIf various types of distortion occur, see the [POSITION] menu → [SCREEN ADJUSTMENT]. (Æpage62 or 64)[DETAILED] input guide[SIMPLE] input guideIf there is no signal input ([COMPUTER1],[COMPUTER2], [HDMI1] or [HDMI2]) , thisscreen will be displayed. Check the outputsettings of your computer.ENGLISH-45Chapter 3Basic Operations - Projecting
