[PROJECTOR SETUP] menuOn the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the submenu.Refer to "Navigating through the menu" (Æ page 53) for the operation of the menu screen.fAfter selecting the item, press asqw to set.[STATUS]You can check the using status of the projector.1) Press as to select [STATUS].2) Press the button.f The [STATUS] screen is displayed.[SIGNAL] [NAME] Displays the name of input signal.[FREQUENCY] Displays the scanning frequency of input signal.[RUNTIME]*1[PROJECTOR] Displays the current usage time of projector.[LAMP (ET-LAV400*2)] Displays the model No. of the replacement lamp unit for thisprojector.[NORMAL] Displays the lamp runtime when [LAMP POWER] is set to[NORMAL] by actual time.[ECO] Displays the lamp runtime when [LAMP POWER] is set to [ECO]by actual time.[SERIAL NUMBER] [PROJECTOR] Displays the serial number of the projector.*1 The following conversion is required to calculate the rough estimate for lamp replacement.Formula for lamp replacement time (rough estimate)A × 1 + B × 5/7f A : Runtime which is displayed in [STATUS] screen → [RUNTIME] → [LAMP] → [NORMAL]f B : Runtime which is displayed in [STATUS] screen → [RUNTIME] → [LAMP] → [ECO]*2 The model No. of the optional lamp unit is subject to change without prior notice.[COMPUTER1 INPUT SETTING]Set whether to use the terminal.1) Press as to select [COMPUTER1 INPUT SETTING].2) Press qw to switch the item.f The items will switch each time you press the button.[RGB/YPBPR] Select when you want to input the RGB or YPBPR (YCBCR) signal to terminal.[Y/C] Select when you want to input a luminance signal and a color signal to terminal.[COMPUTER2 SELECT]Set whether to use the terminal.1) Press as to select [COMPUTER2 SELECT].2) Press qw to switch the item.f The items will switch each time you press the button.[COMPUTER2 IN] When input the computer signal.[COMPUTER1 OUT] Outputs the signal which has been input terminal.78 - ENGLISHChapter 4 Settings - [PROJECTOR SETUP] menu