Panasonic SDR-S100 Operating Instructions Manual

Also see for SDR-S100: Operating instructions

Contents

14VQT0T60∫ Install a button-type battery (supplied) in the remote control1) While pressing the stopper 1, pull outthe battery holder.2) Set the button-type battery with its (i)mark facing upward 2 and get thebattery holder back in place.∫ About the button-type battery≥ When the button-type battery runs down, replace it with a new battery (CR2025).The battery typically lasts about one year; the actual life may be less with heavy use.≥ Keep the button-type battery out of the reach of children.∫ Remote control usable rangeThe distance between the remote control and theunit: Within approx. 5 mAngle: Approx. 10o up and 15o down, left, and right1 Remote control sensor≥ The remote control is intended for indooroperation. Outdoors or under strong light, thisunit may not operate properly even within theusable ranges.Parts identification and handling (continued)1 2CautionDanger of explosion if battery isincorrectly replaced. Replace onlywith the same or equivalent typerecommended by the equipmentmanufacturer. Discard usedbatteries according tomanufacturer’s instructions.WarningRisk of fire, explosion and burns. Do notrecharge, disassemble, heat above100 xC or incinerate. Keep theButton-Type battery out of the reach ofchildren. Never put Button-Type batteryin mouth. If swallowed call your doctor.WARNING“THE LITHIUM BATTERY IS A CRITICAL COMPONENT (TYPE NUMBER CR2025MANUFACTURED BY PANASONIC).IT MUST NEVER BE SUBJECTED TO EXCESSIVE HEAT OR DISCHARGE. IT MUSTTHEREFORE ONLY BE FITTED IN EQUIPMENT DESIGNED SPECIFICALLY FOR ITS USE.REPLACEMENT BATTERIES MUST BE OF THE SAME TYPE AND MANUFACTURER.THEY MUST BE FITTED IN THE SAME MANNER AND LOCATION AS THE ORIGINALBATTERY, WITH THE CORRECT POLARITY CONNECTIONS OBSERVED.DO NOT ATTEMPT TO RE-CHARGE THE OLD BATTERY OR RE-USE IT FOR ANY OTHERPURPOSE. IT SHOULD BE DISPOSED OF IN WASTE PRODUCTS DESTINED FOR BURIALRATHER THAN INCINERATION.”1