30VQT0T60Changing the date and time display stylePress the menu button, select[ SETUP]#[ DATE/TIME], then usethe cursor button to select the desireddisplay style. (P27)≥ The date and time display can also bechanged by pressing the [DATE/TIME] buttonon the remote control.∫ About date/time≥ The date and time function are driven by a built-in lithium battery.≥ Make sure to check the time before recording because the built-in clock is not very accurate.≥ If [0] or [– –] is indicated when this unit is turned on, then the built-in lithium batteryruns down. After charging the battery using the steps below, set the clock.∫ Charging the built-in battery for the date≥ Connect the AC adaptor to this unit or place the battery on this unit, and the built-inlithium battery will be recharged. Leave this unit as is for approx. 24 hours, and thebattery will save the date and time for approx. 6 months. (Even if the [ON/OFF]switch is set to [OFF], the battery is still being recharged.)Adjusting the brightness and colour level of the LCD monitor1 Press the menu button, then use thecursor button to set[ SETUP]#[ LCD SET]#[YES].(P27)2 Press the cursor button up or down toselect the item to be adjusted. Then,press the cursor button left or right tomake the adjustment.The bar display moves.– : Brightness of the LCD monitor– : Colour level of the LCD monitorSetting date and time (continued)MENUSETUP ENTER EXITDISPLAYFORMAT CARDDATE/TIMEQUICK STARTSETUPOFFD/TDATE1/3DATE FORMATAdjusting LCD monitor[OFF][D/T]15:4215. 12. 2005[DATE]15. 12. 2005MENUSETUP ENTER EXITPOWER SAVELCD SETBEEP SOUNDINITIAL SETSETUPYESNO2/3LCD AILCD SETMENUSETUP ENTERSETEXIT≥ These settings will not affect the images actually recorded.
