Panasonic SDR-S100 Operating Instructions Manual

Also see for SDR-S100: Operating instructions

Contents

81VQT0T60After the driver and software applications are installed, the unit must be connected tothe PC and be correctly recognized by the PC.≥ Connect after installing the driver and software applications.If you connect this unit to a PC before installation, this unit may not be properly recognized.≥ If a CD-ROM is inserted in the PC, remove it. (If the CD launcher is running, waituntil it finishes, then remove the CD-ROM.)≥ If the recognition procedure is not accomplished properly, operation will not bepossible after connecting the unit to the PC.≥ If the unit fails to operate normally, it may mean that you have not conducted theinstallation or recognition procedure properly.≥ Use AC adaptors as the power supply for the unit and the equipment connected to it.¬ Connect this unit to the AC adaptor.1 Select this unit’s operation mode.≥ When this unit is in still picture playback mode, connect it to a printer supportingPictBridge. (P68)2 Open this unit’s terminal cover, thenfirmly plug one end of the USB cable 1(supplied) into the USB terminal and theother end into the terminal on the PC.≥ Insert the plugs as far as they will go. The unitand PC will not operate properly if they are notinserted fully.≥ Do not use any other USB cables except thesupplied one. (Operation is not guaranteedwith any other USB cables.)≥ When the unit is set to PC Connection mode and connected to a PC, theoperation mode cannot be changed and its power cannot be turned off.In this case, unplug the USB cable (P85), change the operation mode and then turnoff its power.Connection and recognition proceduresPCMotion picture recording Web camera (P79)Motion picture playback UnavailableStill picture recording Web camera (P79)Still picture playback UnavailablePC Connection mode MotionSD STUDIO (P83)Card reader/writer function