13 Configure the alarm settings [Alarm]The settings relating to alarm occurrences such as settings for the alarm action at an alarm occurrence oralarm images, the VMD area settings, audio detection settings, and the alarm occurrence notification can beconfigured on this page.The “Alarm” page has the [Alarm] tab, the [VMD area] tab, the [Audio detection] tab, and the [Notification] tab.13.1 Configure the settings relating to the alarmaction [Alarm]Click the [Alarm] tab on the “Alarm” page. (®page 42, page 44)The settings relating to the alarm can be configured in this section. Refer to page 120 and page 118 for furtherinformation about the settings relating to the alarm images and the alarm output terminal.Alarm[Terminal 1]SFx311SFx310SPN311SPN310SPW311LSPN531SPW531LDetermine how to use terminal 1.• Off: Not used.• Alarm input: Receives alarms. When “Alarm input” is selected, a pull-down menu for “Close” and“Open” is displayed.– Close: An alarm is detected when the terminal status is changed to “Close”.– Open: An alarm is detected when the terminal status is changed to “Open”.• Black & white inputSFx311SPN311SPW311LSPN531SPW531L : Receives the black & whiteswitchover input. (When the input is set to On, the black & white mode is activated.)• Auto time adjustment: Receives the time adjustment input. When the signal is received and if the clockis within 29 minutes ± the hour, the time will be adjusted to 00 minutes 00 seconds. When the time settingis moved back by less than 5 seconds, the time is not changed. When “Auto time adjustment” is selected,a pull-down menu for “Close” and “Open” is displayed.– Close: The time is adjusted when the terminal status is changed to “Close”.– Open: The time is adjusted when the terminal status is changed to “Open”.• Default: Off[Terminal 2]SFx311SFx310SPN311SPN310SPW311LSPN531SPW531LDetermine how to use terminal 2.116 Operating Instructions13 Configure the alarm settings [Alarm]