11.2 Configure the settings relating to JPEG images[JPEG/H.264]Click the [JPEG/H.264] tab on the “Image/Audio” page. (®page 42, page 44)“Live” page (Initial display)Configure the settings relating to the initial images displayed on the “Live” page.[Initial display stream]Select the image to display on the “Live” page from the following.H.264(1)/H.264(2)/H.264(3)/H.264(4)/JPEG(1)/JPEG(2)/JPEG(3)• Default: H.264(1)[Refresh interval (JPEG)*]Select an interval to refresh the displayed JPEG image from the following.0.1fps/ 0.2fps/ 0.33fps/ 0.5fps/ 1fps/ 2fps/ 3fps/ 5fps/ 6fps*/ 10fps*/ 12fps*/ 15fps*/ 30fps*• Default: 5fpsNote• When “On” is selected for “H.264 transmission”, the refresh interval may be longer than the set valuewhen any value with an asterisk (*) on the right is selected.• Depending on factors such as the network environment, the resolution, the image quality, or the numberof computers concurrently accessing the camera, the transmission interval may be longer than the setvalue.• If images are not delivered in the specified transmission interval, you can make the images be deliveredcloser to the specified time by lowering the resolution or image quality.[Image quality (JPEG)]Select the image quality of JPEG images displayed initially on the “Live” page.• Default: Quality1JPEGConfigure the settings such as “Image capture size”, “Quality1”, and “Quality2” of “JPEG(1)”, “JPEG(2)”, and“JPEG(3)” on this section. Refer to page 79 for further information about the settings relating to H.264 images.Operating Instructions 7711 Configure the settings relating to images and audio [Image/Audio]
