Snap shot buttonClick this button to take a picture (a still picture). The picture will be displayed on a newly opened window.When right-clicking on the displayed image, the pop-up menu will be displayed. It is possible to save theimage on the PC by selecting “Save” from the displayed pop-up menu.When “Print” is selected, printer output is enabled.Note• For the case of using Windows 8, Windows 7 or Windows Vista, the following settings may berequired.Open Internet Explorer, click [Tools] ® [Internet Options] ® [Security] ® [Trusted Sites] ®[Sites]. Register the camera address on [Website] of the displayed trusted windows. Afterregistration, close the web browser, and then access the camera again.• When it takes longer than the specified period to obtain the snap shot picture due to the networkenvironment, the snap shot picture may not be displayed.Mic input button*4SFx311SPN311SPW311LSPN531SPW531LSFN310SPN310Turns on/off the audio reception (hear audio from the camera on a PC). This button will be displayed onlywhen “Mic input”, “Interactive(Full-duplex)” or “Interactive(Half-duplex)” is selected for “Audio transmission/reception” on the setup menu. (®page 110)When this button is clicked, the button will turn into the button and audio from the camera will not beheard.Audio volume can be adjusted (Low/ Middle/ High) by moving the volume cursor .Note• The volume cursor is not displayed when “Audio recording” or “Audio detection” is used.Audio output button*4SFx311SPN311SPW311LSPN531SPW531LTurns on/off the audio transmission (play audio from the PC on the unit speaker). This button will bedisplayed only when “Audio output”, “Interactive(Full-duplex)” or “Interactive(Half-duplex)” is selected for“Audio transmission/reception” on the setup menu. (®page 110)The button will blink during the audio transmission.When this button is clicked, the button will turn into the button and audio from the PC will not be heard.Audio output volume can be adjusted (Low/Middle/High) by moving the volume cursor .Note• When a user is using the audio transmission function with “Interactive(Half-duplex)” selected, thereceiver button and the transmission button will be inoperable for the other users. When“Interactive(Full-duplex)” is selected, the transmission button is inoperable for other users.• The duration of continuous audio transmission can be configured in the [Audio] tab of the setupmenu. Audio transmission stops when the specified time has passed. To turn the audiotransmission function on, click the [Audio output] button again.• When the camera is restarted, the adjusted volume level (for both the audio transmission andreception) will return to the level that had been set on the [Audio] tab on the setup menu.(®page 110)• Actual volume level will change in three steps even though the volume cursor can be adjustedminutely.SD recording status indicatorThe status of the SD recording can be checked with this indicator.When the SD recording starts, the SD recording status indicator will light red. It will go off when the SDrecording stops.This indicator will be displayed when “Manual” or “Schedule” is selected for “Save trigger” on the setupmenu. (®page 55)Operating Instructions 131 Monitor images on a PC
