Management and Control2-39161-A2-GH30-30 April 1998When the communication (COM) port is configured as the IP management link,the async terminal interface is accessible through Telnet.When this is the case, you also need to enable Telnet session configurationoptions.Menu selection sequence:Main Menu→Configuration→User Interface→Telnet/FTP SessionYou must also have an IP address and a subnet mask assigned.Menu selection sequence:Main Menu→Configuration→Management and CommunicationSee Table 5-12, Telnet/FTP Session Options, in Chapter 5,Setting Up.In addition, if you want to access the configuration files (upload, download), ordownload new firmware files to the T1 access unit, you must set the FTP Sessionconfiguration option to Enable.Configuring an External Device (Connected to the COM Port)The T1 access unit can be managed remotely by connecting an external devicelike a modem or PAD (packet assembly/disassembly) facility to the COM port.97-15188-01VT100 Emulationand Telnet orNMS using SNMPSNMPNMSWAN LinkExternalModemT1NetworkPSTNAsync orVT100Terminal-or-SimpleASCIIInterfaceT1 AccessUnitCOMPortExternalModemUsing this out-of-band example, configure call processing using the followingpertinent configuration options, configured from the user interface.Menu selection sequence:Main Menu→Configuration→User Interface→External Device (COM Port)— External Device Commands— Dial-In Access— Port UsageSee Table 5-11, External Device (COM Port) Options, in Chapter 5,Setting Up.
