6-5 Setup WizardAC30 series Variable Speed InverterMotor DataSelection of the motor type, control mode and setting the motor control and process control parameters. The Validity column indicates whichparameters are shown, dependent on the control mode.PNO ParameterValidityCommentIMVHzIMVECT PMAC AFESetup Motor? Select TRUE to configure the motor parameters, FALSE to skip thissection0511 Motor Type or AFE ● ● ● ● Selects the motor type.0512 Control Strategy ● ● Selects between Volts/Hz and Vector Control.1533 Control Type ● ● Only visible if Vector Control is selected.Selects between Sensorless Control, and Closed Loop Control (withencoder).1743 Encoder Feedback ● ●0976 Nominal Supply ● ● Defines the default value for the motor frequency parameters.0457 Base Frequency ● ● The base frequency on the motor name plate0456 Base Voltage ● ● The rated voltage on the motor name plate0458 Motor Poles ● ● The number of motor poles. Always enter an even number.0455 Rated Motor Current ● ● Current rating from the motor name plate.0460 Motor Power ● ● Power rating from the motor name plate.0459 Nameplate Speed ● ● Nominal speed from the motor name plate.0461 Power Factor ● Power factor from the motor name plate, (often shown as φ). If this isnot available then leave this at the default value.0555 PMAC Max Speed ● The motor’s maximum speed.0556 PMAC Max Current ● The motor’s maximum current0557 PMAC Rated Current ● The motor’s rated current.0558 PMAC Rated Torque ● The motor’s rated torque0559 PMAC Motor Poles ● The number of motor poles. Always enter an even number.0560 PMAC Back EMF Const KE ● The motor’s Back EMF line to line, rms value (Ke, Volts rms per 1000rpm)1387 PMAC Base Volt ● Rated motor rated voltage in Volt rms0561 PMAC Winding Resistance ● The motor’s resistance, line to line at 25 °C.0562 PMAC Winding Inductance ● The motor’s inductance line to line at maximum current0563 PMAC Torque Const KT ● Torque constant (Kt, Nm/A rms).1808 PMAC Encoder Offset ●1809 PMAC Wiring ●0565 PMAC Therm Time Const ● The motor’s thermal time constant0564 PMAC Motor Inertia ● The motor’s inertia0478 PMAC SVC Start Cur ● The current level during the startup procedure.
