Appendix F: BRS Installation ProcedureWinLink User and Installation Guide Version 1.750 14-160Figure 14-3: BRS Channel Settings Pre-Transition8. Perform the remainder of the Installation procedure as defined inthe Installation section.BRS Link ConfigurationThe BRS link is reconfigured during the Link Installation or the LinkConfiguration wizards, or from the Air Interface screen.Both sites in a BRS Link must be configured identically.Any changes to the frequency settings cause the link to re-synchronize.A short loss of service will occur during re-synchronization.To Configure BRS Channel Settings1. Set the Band Plan.2. Select the Bandwidth required,Single BandDouble Band3. Select the Frequency from the pull-down menu.4. Click Next. The system is re-synchronized to the changes.Note
