Sanyo PLC WM5500L Owner's Manual

Contents

11⑦ R/C jACKWhen using the wired remote control, connect the wired remotecontrol to this jack with a remote control cable (not supplied)(p.15).⑮ USB CONNECTOR (Series B)Use this connector when controlling a computerwith the remote control of the projector. Connectthe USB terminal of your computer to thisconnector with a USB cable (p.19).⑭ AUDIO jACKConnect the audio output (stereo) signal from acomputer or video equipment (p.21).⑪ VIDEO INPUT jACKConnect the component or the composite videooutput signal from video equipment to thesejacks (p.20).③ CONTROL PORT CONNECTORWhen controlling the projector with RS-232C, connect thecontrol equipment to this connector with the serial control cable.(p.19)⑧ HDMI TERMINALConnect the HDMI signal (including sound signal) from videoequipment or the DVI signal from computer to this terminal (pp.19,20).is registered trademarks of HDMILicensing, LLC.⑤ COMPUTER INPUT TERMINAL (ANALOG)Connect the computer (or RGB scart) output signal to thisterminal (pp.19-20).⑨ 5 BNC INPUT jACKSConnect the component or composite videooutput signal from video equipment to VIDEO/Y, Pb/Cb, and Pr/Cr jacks or connect thecomputer output signal (5 BNC Type [Green,Blue, Red, Horiz. Sync, and Vert. Sync.]) to G,B, R, H/V, and V jacks (pp.19-20).③Part Names and Functions⑩ S-VIDEO INPUT jACKConnect the S-VIDEO output signal from videoequipment to this jack (p.20).⑬ AUDIO 1 jACKConnect the audio output (stereo) signal from acomputer or video equipment (p.21).④ ⑤ ⑧⑪ ⑬ ⑥ AUDIO OUTPUT jACK (VARIABLE)This jack outputs the audio signal from computer or video orHDMI equipment to external audio equipment (p.21). Kensington Security SlotThis slot is for a Kensington lock used to detertheft of the projector.*Kensington is a registered trademark of ACCO BrandsCorporation.① INFRARED REMOTE RECEIVER (Back)The infrared remote receiver is also located in the front and top(pp.10, 15).④ ANALOG OUT TERMINALThis terminal can be used to output the incoming analog RGBsignal from INPUT 1-3 terminal to the other monitor (pp.19-20).⑥ ⑦⑭⑫⑨②⑮② LAN CONNECTION TERMINALConnect the LAN cable (refer to the owner’s manual of “NetworkSet-up and Operation”).①⑩⑫ AUDIO jACKS (L(MONO)/R)Connect the audio output signal from videoequipment connected to ⑩ or ⑪ to this jack.For a monaural audio signal (a single audiojack), connect it to the L (MONO) jack (p.21).Rear Terminal