Sanyo PLC WM5500L Owner's Manual

Contents

91AppendixThe command is sent from PC to the projector with theformat below;'CR' [Command] 'CR'Command: one character (refer to the command tablebelow.The projector decodes the command and returns the'Character string' with the format below;FormatThe tables on page 90 and 91 show the typical command lists for controlling the projector. Please consult your local dealerfor further information of other commands.Command Function ProjectorReturn Projector statusCR0 Status Read00 Power On80 Stand-by mode40 Countdown20 Cooling down10 Power Malfunction28 Cooling down at the temperature anomaly24 Cooling down at Power Management mode04 Power Management mode after Cooling down21 Cooling down after the projector is turned off when the lampsare out.81 Stand-by mode after Cooling down when the lamps are out.88 Stand-by mode after Cooling down at the temperatureanomaly.2C Cooling down when the projector is turned off by the shuttermanagement function.8C Stand-by mode after cooling down by the shutter managementfunction.CR6 Temperature Read S1 S2 S3S1 = Temperature at Sensor 1 (˚C)S2 = Temperature at Sensor 2 (˚C)S3 = Temperature at Sensor 3 (˚C)(ex.) S1 = 12.3˚C, S2 = 23.4˚C, S3 = 34.5˚C, S2 = 23.4˚C, S3 = 34.5˚CS2 = 23.4˚C, S3 = 34.5˚C--> The projector displays “12.3 23.4 34.5”(For each sensor, two digit and the tenth place numbers aredisplayed with a space between each temperature.)? Communication failureStatus Read Command

/ 92

Related manuals for Sanyo PLC WM5500L