Sanyo PLC WM5500L Owner's Manual

Contents

151 Open the batterycompartment lid.Install new batteries intothe compartment.Replace thecompartment lid.Press the lid downward andslide it. Two AAA size batteriesFor correct polarity (+ and–), be sure battery terminalsare in contact with pins in thecompartment.To ensure safe operation, please observe the following precautions :● Use two (2) AAA or LR03 type alkaline batteries.● Always replace batteries in sets.● Do not use a new battery with a used battery.● Avoid contact with water or liquid.● Do not expose the remote control to moisture or heat.● Do not drop the remote control.● If the battery has leaked on the remote control, carefully wipe the case clean and install newbatteries.● Risk of an explosion if battery is replaced by an incorrect type.● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.Point the remote control toward the projector (to Infrared RemoteReceivers) when pressing the buttons. Maximum operating rangefor the remote control is about 16.4’ (5 m) and 60 degrees in front,back and top of the projector.Infrared Remote Receivers are provided in front, back and top of ofthe projector. You can conveniently use all of the receivers (pp. 10,11, 59).16.4’(5 m)The remote control can be used as a wired remote control. Wiredremote control helps you use the remote control outside of theoperating range (16.4’/ 5 m). Connect the remote control and theprojector with the remote control cable (sold separately). Connectedwith the remote control cable, the remote control does not emitwireless signal.Part Names and Functions16.4’(5 m)Note:When hanging the projector from the ceiling, select the InfraredRemote Receiver which is located farther away from the fluorescentlight (p.59).Remote Control Battery InstallationWired Remote Control TransmitterRemote Control Receivers and Operating Range