9AC Power Cord for the United Kingdom:This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pin face ofthe plug. Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must be used of the same rating,marked thus ASA. If the fuse cover is detachable, never use the plug with the cover omitted. If a replacement fuse coveris required, ensure it is of the same colour as that visible on the pin face of the plug (i.e. red or orange). Fuse coversare available from the Parts Department indicated in your User Instructions.If the plug supplied is not suitable for your socket outlet, it should be cut off and destroyed.The end of the flexible cord should be suitably prepared and the correct plug fitted.WARNING: A PLUG WITH BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED IN A LIVE SOCKETOUTLETThe Wires in this mains lead are coloured in accordance with the following code:Green-and-yellow ············· EarthBlue ································· NeutralBrown ······························ LiveAs the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifyingthe terminals in your plug proceed as follows:The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the letterE or by the safety earth symbol or coloured green or green-and-yellow.The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.WARNING: THIS APPARATUS MUST BE EARTHEDThe AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.AC Power Cord for the United States and Canada:AC Power Cord used in the United States and Canada is listed by the UnderwritersLaboratories (UL) and certified by the Canadian Standard Association (CSA).AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that theplug will fit into the power outlet. Do not try to defeat this safety feature. Should you be unableto insert the plug into the outlet, contact your electrician. GROUNDTHE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILy ACCESSIBLEAC Power Cord RequirementFederal Communications Commission NoticeNote: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed andused in accordance with the instructions, may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference toradio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to tryto correct the interference by one or more of the following measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.– Consult the dealer or an experienced radio/TV technician for help.Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of FCC Rules.Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If suchchanges or modifications should be made, you could be required to stop operation of the equipment.Model Number : PLC-WM5500, PLC-WM5500LTrade Name : SanyoResponsible party : SANYO NORTH AMERICA CORPORATIONAddress : 21605 Plummer Street, Chatsworth, California 91311, U.S.A.Telephone No. : (818)998-7322Compliance