4Select the desired screen size that conforms to the input signalsource.SCREEN MENUProvide the image within a screen size keeping its original aspect ratio.Note:• The projector cannot display any resolution higher than1920 x 1200. If your computer’s screen resolution ishigher than 1920 x 1200, lower the resolution beforeconnecting the projector.• The image data other than 1280x 800 is modified to fitthe screen size in initial mode.• Full, Wide(16:9), Zoom, True and Digital zoom +/–cannot be selected when no signal is detected in thePC System Menu. (p.36)1Press the MENU button to display the On-Screen Menu. Usethe Point ▲▼ buttons to select Screen and then press thePoint ► or the SELECT button.Use the Point ▲▼ buttons select the desired item and thenpress the SELECT button.To reset the adjusted data, select Reset and press the SELECTbutton. A confirmation box appears and then select yes. Alladjustments will return to their previous figures.To store the adjusted data, select Store and press the Point ► orthe SELECT button. Use the Point ▲▼ buttons to select one fromImage 1 to 10 and press the SELECT button.A confirmation box appears and then select yes. Stored data canbe called up by selecting an Image (1-10) in the Image ModeSelection on page 40.A confirmation box appears andthen select yes.StoreComputer InputResetStoreScreen Size AdjustmentNormalProvide the image in its original size. When the original image sizeis larger than the screen size (1280 x 800), the projector enters tothe panning mode automatically. Use the Point ▲▼◄► buttonsto pan the image. When adjusted, the arrows will turn red. Whenreached to the correction limits, the arrows will disappear.Scale the image proportionally to fit the entire screen. Either side ofimage may go over the screen.TrueZoomProvide the image to fit full screen size.FullProvide the last stored aspect screen image.CustomProvide the image at the 16:9 wide screen ratio.Wide (16:9)