Sanyo PLC WM5500L Owner's Manual

Contents

9AppendixThis projector provides a function to control and monitor the projector's operations by using the RS-232C serial port.Connect a RS-232C serial cross cable to CONTROL PORTon the projector and serial port on the PC. (See p.19)Launch a communication software provided with PC andsetup the communication condition as follows:1Baud rate : 9600 / 19200 bpsParity check : noneStop bit : 1Flow control : noneData bit : 8Type the command for controlling the projector and then enterthe "Enter" key.ExampleWhen you want to change the input to INPUT 2, Type 'C' '0' '6''Enter'.Note:Enter with ASCII 64-byte capital characters andone-byte characters.Note:The default of the baud rate is set to19200 bps. If an error occurs in thecommunication, change the serial port andthe communication speed (baud rate).Serial Control InterfaceOperationList of Picture in Pictureo : Picture in Picture combinations are enabled.x : Picture in Picture combinations are disabled.Note:• When the input signal(s) is/are incompatible, X mark will be displayed on the Main/Sub picture.• Depending on the frequency or signal type of PC/AV input, the display resolution may be lowered or images may not be displayed onthe Main/Sub picture.• Inputting PC analog signals: Between 100-140 MHzmages are not displayed and X mark appears when;>• Inputting PC analog signals: More than 140MHz• Inputting PC digital signals: More than 100MHz• Inputting AV digital signals: 1080p• Inputting signal formats: SXGA20, WUXGA 1, WUXGA 2, WSXGA+ 1, WXGA+2, UXGA 1, UXGA 2, UXGA 3, UXGA4, D-1080p

/ 92

Related manuals for Sanyo PLC WM5500L