Sanyo PLC-XE30 Owner's Manual

Contents

36Video InputChoose Computer 1 by pressing the INPUT button on thetop control or press the COMPUTER button on the remotecontrol.Before using these buttons, correct input source should beselected through Menu operation as described below.Press the MENU button to display the On-ScreenMenu. Press the Point 7 8 buttons to move the redframed pointer to the Input Menu icon.1Computer1Input MenuPress the Point ed buttons to move the red arrowpointer to Computer 1 and then press the SELECTbutton.2After the Source Select Menu appeared for Computer1, move the pointer to Component or RGB(Scart) andthen press the SELECT button.3Computer 1VideoComputer 2COMPUTER buttonComputer 1Computer 2INPUT buttonInput Source Selection (Component, RGB Scart 21-pin)Direct OperationMenu OperationMove the pointer (redarrow) to Computer 1and press the SELECTbutton.Input Menu iconMove the pointer toComponent or RGB(Scart)and press the SELECTbutton.Source Select MenuREMOTE CONTROLTOP CONTROLCOMPUTER buttonWhen the input source is coming fromvideo equipment connected to theCOMPUTER IN 1 / COMPONENT INterminal with a Component-VGA Cable,select Component.ComponentWhen the input source is coming fromvideo equipment connected to theCOMPUTER IN 1 / COMPONENT INterminal with a Scart-VGA Cable, selectRGB (Scart).RGB (Scart)✳✳✳ See Note at the bottom of this page.INPUT buttonON - OFFPOWERKINPUTWARNING LAMENU- VOSELECThttp://www.pureglare.com.au