Sanyo PLC-XE30 Owner's Manual

Contents

52Antitheft Alarm FunctionHow to install the batteryTo use the Antitheft alarm function, a battery needs to beinstalled. (Use a CR2 3V lithium battery.)To install the battery, remove the screw and open thebattery cover on the bottom of the projector.When the battery is installed properly, the ALARM indicatorwill blink for a few seconds.After placing the battery, put the cover back and secure itwith the screw.When the life of the battery draws to an end, the ALARMindicator will flash and warning sound will be made at someintervals.Replace the battery with following the procedures above.✔Note:•Even after changing the battery, the PIN code you have changedand settings you have made is effective.•When changing the battery, set the Antitheft function off.Otherwise the alarm will start ringing when you try to open thebattery cover.Loosen the screw andopen the battery cover.Install the battery then replace thebattery cover and secure it with thescrew.ScrewTo insure safe operation, please observe the following precautions:● Do not keep the battery with mixing with wire or metal products to avoid causing a short.● Keep the battery away from babies and children to prevent them from swallowing it.● Do not charge the battery.● Do not disassemble, or apply pressure to transform the battery.● Avoid contact with water or liquid.● Do not expose to moisture or heat.● If the battery has leaked, carefully wipe the battery compartment clean and install new battery.● Do not replace the battery with an incorrect type or in a incorrect direction.● Dispose of used battery after insulating the battery with putting insulating tape on either or bothsides on the top/bottom of the battery.● Dispose of used battery with following local regulations.http://www.pureglare.com.au