Tascam DM-24 Owner's Manual

Also see for DM-24: User guide Basic guide Quick start guide Basic guide Installation information

Contents

17 – Specifications—Messages and troubleshootingTASCAM DM-24 Reference Manual 129✖ Can’t do MIDI Bulk Loadwith timecode runningShown if an attempt is made to load Bulk Data with timecode running (“Bulktransfer of data to the DM-24” on page 96)✔ Can’t assign fader grouping layer. Shown when an invalid fader grouping is attempted (“Grouping layers” onpage 71).✔ Can’t assign mute grouping layer. Shown when an invalid mute grouping is attempted (“Grouping layers” onpage 71).✔ Can’t Dump MIDI Sys Ex data.SysEx filter is set in MIDI/MC[SETUP] screen]Press ENTER to continue.Shown if a MIDI filter has been set up preventing MIDI System Exclusive trans-mission (“MIDI filtering” on page 84) and an attempt is made to dump data.● Can’t Recall COMP Libraryxxx. The compressor library entry xxx cannot be recalled as it does not exist (nodata has been written to that library entry) — “Library functions” on page 99● Can’t Recall Effect U1-xxx. The user effect 1 library entry xxx cannot be recalled as it does not exist (nodata has been written to that library entry) — “Library functions” on page 99● Can’t Recall EQ Libraryxxx The EQ library entry xxx cannot be recalled as it does not exist (no data hasbeen written to that library entry)—“Library functions” on page 99● Can’t recall GATE/EXP Libraryxxx. The gate/expander library entry xxx cannot be recalled as it does not exist (nodata has been written to that library entry (“Library functions” on page 99)● Can’t recall Snapshotxxx. The snapshot xxx cannot be recalled as it does not exist (no data has been writ-ten to that library entry)● Can’t recall to Chxx.GATE/EXP is not inserted.An attempt has been made to load gate/expander settings from the library to amodule where a gate or expander has not been inserted (“Library functions” onpage 99).✔ Can’t select dual-lineDifferent Fs modePress ENTER key to continue.An attempt has been made to select dual-line transmission in normal samplingfrequency mode (must be “normal”)— “High sampling frequency” on page 112.✔ Can’t select dual-lineDifferent Fs modePress ENTER to continue.An attempt is made to select the dual-line format in normal sampling frequencymode (“High sampling frequency” on page 112).● Can’t STORE Automation Bank01. Shown if there is a problem overwriting a protected memory bank (automation)✖ Cascade connection broken!Press ENTER to continue.Shown on cascade master when an existing cascade connection has becomedisconnected or is otherwise inoperative (“Cascade card” on page 119).✔ Ch parameters Setup?Press ENTER to confirm,or a cursor key to cancel.Shown when a global screen has been used to make changes to a range ofchannels at one time (for instance aux sends, digital delay, etc.), (“Module oper-ations” on page 49.)● CH x is already inserted. An attempt has been made to assign a second insert loop to a channel whichhas already had an insert loop assigned to it (“Assignable returns” on page 36).✔ Clear all fader grouping layers ?Press ENTER to confirm,or a cursor key to cancel.Shown when the on-screen CLEAR button has been pressed to clear all fadergroups (“Grouping layers” on page 71).✔ Clear all muting grouping layers ?Press ENTER to confirm,or a cursor key to cancel.Shown when the on-screen CLEAR button has been pressed to clear all mutegroups (“Grouping” on page 69).✔ Clear Current Automation Event Data?Press ENTER to confirm,or a cursor key to cancel.Shown in automation, when the current data is to be cleared (using soft key 2)Action Message Explanation