7 – Module operations—UTILITY copying62 TASCAM DM-24 Reference ManualUTILITY copyingThis screen allows the aux send levels and pan set-tings for a group of channels to be set up to mirrorthe settings made on the channel faders, and the otherway around. This may be useful when setting up astudio monitor mix, for example, and the levels andpans of the aux sends used for the monitor mixshould initially be set to the same as the channels.The screen above allows these copies to be madefrom one screen.1 With the SHIFT indicator lit, press theUTILITY key.There is only one screen, as shown here.2 Check either of the two checkboxes (PAN/BALand/or LEVEL) to select the settings to be cop-ied.3 In either of the two boxes, select either theAUX -> CH or the CH -> AUX setting radio but-ton.Naturally, it is not possible to select both inthe same box, though it is possible to selectCH -> AUX in one box and AUX -> CH in theother.4 Select the source and the destination parame-ters as explained here.For pan/balance settings, aux sends must be linked tobe used as either sources or destinations. It is not pos-sible to select individual aux sends here.The aux sends are selectable individually or as linkedpairs as sources or destinations for level copying.Channels are divided into blocks of eight: 1-8, 9-16,17-24, 25-32 and ALL. Individual channels cannot beselected.5 Move the cursor to the on-screen COPY buttonand press ENTER. A confirmation popupmessage appears.6 Press ENTER again to confirm the copy, or acursor key to cancel.If neither of the checkboxes is checked when youpress the COPY button, an error message is displayed.