Tascam DM-3200 Release Notes

Also see for DM-3200: Quick reference Owner's manual Manual Software guide Application guide

DM-3200 Release Notes10 TASCAM DM-3200 Release Notes V1.50New Features in V 1.20FireWire card supportBy installing an IF-FW/DM FireWire interface card (soldseparately), it is now possible to transfer audio data betweenyour computer and a DM-3200. An IF-FW/DW card canonly be installed into Slot 1.Surround monitor card supportIntegrated surround monitoring can be added to theDM-3200 by installing an IF-SM/DM surround monitorcard (sold separately). An IF-SM/DM card can be installedinto either Slot 1 or 2.Naming the mixerDM-3200 Ver1.20 allows you to set and edit mixer names.Remote operation through MMCNow you can remotely operate external transports from aDM-3200 using the MMC (MIDI Machine Control) protocol.MIDI controlExternal MIDI devices can be controlled from the DM-3200using MIDI Control Change and Program Change Messagesusing the new external controllers: MIDI fader, MIDI control-ler, and MIDI mixer.Assigning parameters to rotary encodersDM-3200 now allows you to assign which parameters arecontrolled from the rotary encoders.Cascade connectionA cascade connection can be made between two DM-3200 units.GPI functionalityDM-3200 can now remotely control external devices usinga GPI signal output.Expanded dynamic automation functionThe dynamic automation function of the DM-3200 cannow capture buss assignments, effect parameters, andimage parameters.Scrolling indicators for the supporteddevice list in the machine control screenIf the list of supported devices in the right side of themachine control screen does not fit in the screen, arrowswill appear at the top and bottom.MMC command type addedThe commands transmitted from the DM-3200 when youperform a JOG operation can now be matched to the devicebeing controlled. You can choose either Search (46h) orStep (48h). For details, refer to the operating manual of thedevice you are controlling.This setting is made in the REMOTE>MC SETUP screen'sMMC Command Type area.Figure 14 REMOTE>MC SETUP screenªªTransmission of locate commands whenediting a locate pointWhen you use the EDIT key located in the MACHINECONTROL section of the top panel to ENTER or edit a locatepoint, a LOCATE command is now transmitted when youpress the ENTER key to store the memory.This allows you to locate a connected device at the sametime that you edit the locate point.ª