DM-3200 Release NotesTASCAM DM-3200 Release Notes V1.50 1The following mixer settings cannot be changed whileautomation data is being re-played.Surround modeGrouping settingChannel link settingPan switch setting [Set by SHIFT + OUTPUT ASSIGN]If you try to change the above settings, a pop-up message“cannot do this while automation is running” will appearand the operation will be denied.••••Settings prohibited to change during automation re-playThe following parameters are now captured and re-playedas the Initial Status of the automation (please see “InitialStatus” on page 32 of DM-3200 Automation Guide).Trigger source of the compressorTrigger source of the gateROUTING>INPUT screen settingROUTING>OUTPUT screen settingROUTING>INSERT screen settingPan mode settingSurround pan mode settingDirect assignments settingPan gang button settingDigital trim value settingPhase setting•••••••••••Mono switch settingChannel delay value settingPre/post setting of the channel delayLevel setting of BUSS/AUX signal to stereo bussPan setting of BUSS/AUX signal to stereo bussWith these additions, all of the parameters that can bestored as snapshots are now captured and re-played as theInitial Status.•••••Additional parameters that are re-played as Initial StatusExpanded dynamic automation functionThe following parameters can now be captured andre-played by the dynamic automation function of DM-3200(please see “Automated Controls” on the page 4 of theDM-3200 Automation Guide).ImageImage parameter of the linked channel (please see “Panand balance settings” on page 71 of the DM-3200Owner’s Manual).EffectCommon effect parameters (TYPE, INPUT, MIX, BYPASS,OUTPUT) and TASCAM effect parameters (please see“Setting up the effects” on page 82 of DM-3200 Owner’sManual).AssignmentsThis includes, in addition to the buss assignment andstereo buss assignment, the AUX 1-2 assignment from theBUSS and STEREO BUSS, surround assignment and ON/OFF setting of CSP/LFE speakers (please see “Channel-to-buss assignment” on page 51 and “Assigning channelsto surround busses” on page 75 of the DM-3200 Owner’sManual).NOTEWhen any of the above mentioned parameters is acontinuous variable, the Revert function is applied to it.On the AUTO CONFIG screen, each of these addi-tional parameters is related to an item as shownbelow (please see “AUTO CONGIG” on page 14 of theDM-3200 Automation Guide).parameter itemIMAGEAssign SwtchEffect 1 parametersEffect 2 parametersPAN/BALBUSS ASSIGNEFFECT 1EFFECT2Additional dynamic automation parameters