DM-3200 Release Notes TASCAM DM-3200 Release Notes V1.50Module parameter copy functionYou can now copy module parameters from a module toanother module.PARAM COPY settingsAccess the UTILITY>PARAM.COPY screen. The copy opera-tion is performed in the MODULE TO MODULE section ofthis screen.Figure 10 UTILITY>PARAM.COPY screen1. The upper part of the MODULE PARAMETERS sectionlets you copy from one module to one other module,and the lower part lets you copy from one moduleto multiple modules. Use the radio buttons to selectthe desired type of copy operation.2. Use the cursor keys to move the cursor, use theJOG/DATA dial to select the module that youwant to copy (left side), and press the ENTER key.Select the copy-destination module (right side) inthe same way.3. Move the cursor to the COPY button and press theENTER key.A popup message will ask you for confirmation.4. Press the ENTER key to execute the copy.If you decide to cancel, press any cursor key.PASTE SAFEIn the PASTE SAFE section you can select the parametersthat will be pasted.Parameters whose square check boxes are selected will notbe pasted.You can copy/paste from a CHANNEL to a master modulesuch as a BUSS or AUX, or the reverse. In this case,parameters existing at the copy-source but not the copy-destination will not be copied; they will retain their statefrom before the paste operation. The same applies toparameters that don't exist in the copy-source but do existat the copy-destination.ª The – symbols at the right indicate parameters that exist inthe corresponding modules.NOTEModule functions include some parameters not shownin this list, such as DIGITAL TRIM, but parameters notshown in the list will not be copied/pasted.BUSS pan mode batch setupIn the ASSIGN>BUSS screen, BUSS PAN MODE BATCH SETUPhas been added to allow one-step setup of BUSS pan mode.Figure 11 ASSIGN>BUSS screen1. Move the cursor, use MODULE to select the channel,use TARGET to select the busses whose pan modeyou want to change, and use ON/OFF to specify theon/off setting.2. Move the cursor to the SET button and press theENTER key.A popup message will ask you for confirmation.3. Press the ENTER key to execute the copy.If you decide to cancel, press any cursor key.ªOperation