DM-3200 Release NotesTASCAM DM-3200 Release Notes V1.50 1You can send MIDI Control Change messages to exter-nal MIDI devices using the POD knobs, FADER and theMUTE key of the DM-3200. In the default setting, theycontrol PAN, FADER, and MUTE respectively.Figure 10: MIDI MIXER screenThis operation is possible only when the Layer Status is setto REMOTE and the MIDI MIXER screen is currently show-ing or was the last EXT.CTRL screen displayed. The screenwill show “REM PAN” for the encoder mode, and the encod-ers will control the pan data.When ON/OFF status is set to ON, a check mark appearsin the check box. When it is OFF, the box is blank. In thefigure 11, all the channels are set to ON.You cannot operate the MIDI control of the channel panwhen the surround mode is not set to STEREO.NOTEWhen the Layer Status is set to REMOTE the pan valueis displayed on, and can be controlled with the rotaryencoders.Changing the assignmentYou can change the MIDI channel, Control Changenumber, and ON/OFF status that are assigned to each ofthe POD knobs, FADER, and the MUTE key. Changes aremade on the MIDI>CTRL.CHANGE screen.Figure 11: MIDI>CTRL.CHANGE screenªTo display this screen, either press the MIDI key followedby the POD 3 key (or keep pressing the MIDI key), or movethe cursor to the (Jump to SCREEN) button at the topright on the MIDI MIXER screen, and press the ENTER key.Use the POD 4 knob to select the key whose assignedfunction is to be changed (FADER, PAN or MUTE) in theTARGET section on the right of the screen.You will see a chart showing MIDI channel, ControlChange number, and ON/OFF status of the selected key(channel 1-16) on the left of the screen.Use the cursor key to select the item to be set, select thevalue using the JOG/DATA dial, then press the ENTERkey to set the value. When you are changing the ON/OFFstatus, press the ENTER key.NOTEIf there is more than one key that is assigned to thesame MIDI channel, you cannot assign the sameControl Change number to both of them.A Control Change number can be selected from thefollowing: 1-5, 7-31, 64-95.When ON/OFF status is set to ON, a check markappears in the check box. When it is OFF, the box isblank. In the figure 11, all the channels are set to ON.You cannot operate the MIDI control of the channelpan when the surround mode is not set to STEREO.MIDI mixer