DM-3200 Release Notes1 TASCAM DM-3200 Release Notes V1.50GPI functionalityDM-3200 Ver1.20 supports GPI functionality. This allowsyou to send 8 output signals from the GPI port (D sub9-pin connector) on the rear panel, and control externaldevices from the DM-3200.The DM-3200 allows you to give different trigger settingsto each of the GPI ports for GPI signal output. You canchoose the trigger source from a FADER, MUTE keycontrol, transport control, machine control key status andits operation, or a timecode value.Making connectionsThe arrangement of the serial port pins of the GPI ports onthe rear panel is as follows:Pin number Function#1 GPI output port#2 GPI output port 2#3 GPI output port 3#4 GPI output port 4#5 GND#6 GPI output port 5#7 GPI output port 6#8 GPI output port 7#9 GPI output port 8Output level: 5VSettings that can be interlockedThe following settings are interlocked between the twoDM-3200 units while there is a cascade connectionbetween them. The initial settings on the cascade masterwill be reflected on the cascade slave immediately after acascade connection is established.Layer statusFlip modeEncoder modeSurround modeSurround 5.1 rear MONODIGITAL>CASCADE screen setup (except for ID setting)OPTION>SETUP screen setup (except for FADERSENSITIVITY)OPTION>PREFERENCE screen setupOPTION>SOLO screen setup (except for INPLACE SOLODEFEAT setup)OPTION>ENCODER MODE screen setupMETER/FADER>METER screen setupSNAPSHOT RECALL SAFE setup on the LIBRARY SNAPSHOTscreenAUTO SETUP screen setupºKey setup in the AUTOMATIONsection (WRITE, TRIM, ALL SAFE, REHEARSE, INITIAL EDIT)After the cascade connection has been made, whenevera setting is changed either on the cascade master or thecascade slave, the changed setting will be reflected on thesetting of the other unit. However, the ON/OFF setting ofthe cascade connection can only be changed on the cascademaster.ª•••••••••••••Operations that can be interlockedThe following operations are interlocked while there isan established cascade connection between two DM-3200units. Whenever any of the below operations is executedeither on the cascade master or the cascade slave, the otherwill follow with the exact same operation.Snapshot related operations:RecallStoreDeleteAutomation key operations:TOUCH keyKEEP keyREVERT keyINITIAL EDIT DISCARD keyAUTO FADE keyªSettings and Operations that can be interlocked