DM-3200 Release NotesTASCAM DM-3200 Release Notes V1.50 1This section explains how to make a cascade connectionbetween two DM-3200s that are running Version 1.20.1 Using the TASCAM cascade cable (PW-1000CS –sold separately), connect the CASCADE ports of thetwo DM-3200.WARNINGOnly use the special TASCAM cascade cable. Use ofany other type of cable may result in damage to theequipment.2 Set one of the DM-3200 units to be the cascademaster, and the other the cascade slave.To set the master and slave, display the DIGITAL screenusing the DIGITAL key in the SCREEN MODE/NUMERICENTRY section, and use the POD 3 key (or continue pressingthe DIGITAL key) to display the CASCADE sub-screen. Setthe ID of one of the units to MASTER, and the other to SLAVE.Figure 13: DIGITAL>CASCADE screenNOTESet the unit ID while the ON/OFF set-up is OFF. Youcannot change the ID set-up while it is ON.3 Turn the ON/OFF setting on the CASCADEsub-screen of the cascade master to ON.Move the cursor to the ON/OFF button and press theENTER key. A confirmation screen will come up. Checkthe setting and press the ENTER key again to confirm.NOTEON/OFF status cannot be changed while the timecodeis running.4 When a cascade connection is established, a pop-upmessage “Cascade connection established” will bedisplayed. Press the ENTER key.NOTEIf a cascade connection was not properly established,a pop-up message “Cascade Slave not found. Cascadeconnection not established” will be displayed.Making a cascade connection