Tascam Digital Portastudio DP-24 Owner's Manual

Also see for Digital Portastudio DP-24: Owner's manual addendum Notice Manual Troubleshooting supplement Quick start guide

Contents

Tascam Digital Portastudio DP-24 Owner's Manual Manual pdf 48 page image

48 TASCAM DP-246 - Basic RecordingSetting the stereo positionUse the PAN parameter to set the stereo position.The full left value is L63, and the full right value is R63.The center position is shown by C .Turn the PAN knob to adjust the stereo position.Setting range: L63 to C to R63 (Default: C)Changing the signal phaseWhen the phase is inverted due to the mic wiring or otherreason, use the PHASEØ display area to correct the phase.1. Use the CURSOR (5/b/g/t) buttons to move thecursor to the PHASEØ display area.2. Turn the JOG/DATA dial to change the built-insignal phase.Options:PHASEØ indicator unlit (default): Normal phasePHASEØ indicator lit: Inverted phaseChecking the fader levelCheck the level on the LEVEL display area on the Mixerscreen for each track. Operations cannot be made on thisdisplay.Operations for LEVEL on the Mixer screen for each input(INPUT A to H) are explained below.1. Use the CURSOR (5/b/g/t) buttons to move thecursor to the LEVEL display area.2. Turn the JOG/DATA dial to adjust the level.Setting range: inf to +6.0dBWhen playing back a track, in the initial settings, thepositions of the faders (physical faders) on the top paneland the actual level of the faders (internal faders) are alwaysmatched, but a fader group or MIDI command sent by aremote control to the unit could make them to differ. Evenin this case, when you move a physical fader, the internalfader matches the physical fader value, and thereafter thephysical fader controls the level.CAUTIONA sudden level change may occur.SoloPress the SOLO button to select the Solo mode. The SOLObutton becomes lit.In Solo mode, the REC button of each track works as aSOLO button, so you can monitor the signal of the desiredtrack.The Solo mode of this unit is a solo-in-place monitor, so allother tracks are muted except the one whose REC buttonwas pressed.1. When the Home screen is displayed, press theSOLO button to select the Solo mode.In Solo mode, the SOLO button becomes lit.2. Press the REC button for the track you want to turnsoloing on/off.When Solo mode is activated, the MUTE/SOLOindicator of the track whose REC button was pressedlights.To cancel soloingªIn Solo mode, press the SOLO button or the REC buttonto which track solo is enabled.When Solo mode is deactivated, the MUTE/SOLOindicator of the track whose REC button was pressed goesoff.Muting tracks1. Press the MUTE button to enter Mute mode.In Mute mode, the MUTE button becomes lit.2. Press the REC button for the track you want to turnmuting on/off.When muting is turned on, the MUTE/SOLO indicatorof the track whose REC button was pressed lights.To cancel mutingªPress the MUTE button to enter the Mute mode.Press the REC button of a muted track to cancel muting (itsMUTE/SOLO indicator goes off ).When solo is activated during muting, you can hear thesound, but this does not mean that muting was canceled.PAN indicationPHASEØ indicatorFader level indication