86 TASCAM HS-2010 – Internal settingsRS–422 pageMake RS-422 serial control transmission settings on this page.NOTEIf an optional SY-2 has not been installed, the items will beshaded and cannot be set.Serial ModeSet the serial connection mode with the following buttons.Setting buttons: RS-232C (Default), RS-422NOTE• Only the connector selected with this setting will function.The RS-232C and RS-422 connectors cannot both be usedat the same time.• This setting is synchronized with the Serial Mode item on theRS-232C page.• If an optional SY-2 has not been installed, this cannot be setto RS-422.Video ResolveWhen slaving this unit to a VCR, video sync signals might beused instead of word sync signals for the common standardclock. In the same way as with word sync signals, you canselect whether the video clock is followed (synchronizingthe beginning of timecode frames with video signal frameedges) or it is independent from the frame clock.This must be turned ON to accurately control this unit froma video editor.ON (default): timecode frame edges synchronized withvideo signal frame edgesOFF: Independent from video frame clockNETWORK pageMake settings related to NETWORK communication on thispage.STATUSShows the MAC Address of this unit and the current IPAddress.PasswordPress the Change button to open the CHANGE PASSWORDscreen.IP MODEUse these buttons to enable or disable network functions.Setting buttons: Disable (default), EnableIP SETUPUse this section to set the IP Address, Subnet Mask andDefault Gateway.AUTO: The IP Address, Subnet Mask and DefaultGateway are set automatically.Use this setting when a DHCP server existson the network.STATIC:(default value)Set the IP Address, Subnet Mask and DefaultGateway manually.IP Address/Subnet Mask/Default GatewayWhen IP SETUP is set to STATIC, the IP Address, Subnet Maskand Default Gateway are shown here.Touch an area to open a corresponding setting screen.Default: 0. 0. 0. 0.Depending on the IP SETUP setting, the appearance of thisarea will change as follows:When touchingWhen setting STATICWhen setting AUTODNS SETUPSet the DNS server IP address so that the IP address can belooked up by server name.AUTO: The DNS server IP Address is set automati-cally.Use this setting when a DHCP server thatcan return a DNS server IP address exists onthe network.STATIC:(default value)Set the DNS server IP Address manually.DNS AddressWhen DNS setup is set to STATIC, this shows the DNS serverIP address. Touch it to open a setting screen.Default: 0. 0. 0. 0.