wc_tx003620gb_FM10.fm122Mobile GeneratorHow to Connect Loads11.5 Connecting a 220–240V 3Ø Load and Multiple 127–133V 1Ø Loads1. Stop the engine and turn the main circuit breaker off.2. Set the voltage selector switch to the 240V position.3. Open the lug door and connect the wires from the load(s) as shown.4. Close the lug door and start the machine.5. Fine-tune the voltage as necessary using the voltage adjustment rheostat.Note: Graphic is representative only. Your machine may vary.WARNINGElectric shock hazard. High voltage can cause serious injury or death.► Connections must be made by a qualified electrician.! !When connecting multiple 120V loads:Use L1 as "hot" for first load.Use L3 as "hot" for second load.Use L2 as "hot" for third load.Balance the loadFine-tune the voltage so thatboth the 3-phase load andthe single-phase loadsoperate properly.Fine-tune the voltage127–139V127–139VTOGROUNDLUGwc_gr011548220–240 L-L127–139 L-N220–240V 220–240V127–139V127–139V127–139V220–240V220–240V 3Ø 127–139V 1Ø 127–133V 1ØHOT HOT HOT GN GNWH240V 3Ø
