wc_tx003618gb_FM10.fm56Mobile GeneratorOperation (Basler Controller)7.3 Genset Pre-Alarms and Alarms (Shut-Down Conditions)Background The genset controller monitors variables of engine and machine function. Thegenset controller is programmed to signal pre-alarm conditions, and to shut downthe machine when an alarm condition exists.Pre-alarms Pre-alarm conditions are:■ Low fuel level■ High coolant temperature■ Low oil pressure■ Time to maintenanceDuring a pre-alarm condition, the LCD panel (a) displays the type of pre-alarm, andthe LED (b) flashes. The machine is not shut down.Alarms/shutdownsShut-down conditions are:■ Low fuel level■ High coolant temperature■ Low oil pressure■ Overspeed/Underspeed■ Overcrank■ Low coolant level (if equipped)■ OvercurrentDuring an alarm condition, the LCD panel (a) displays the type of alarm, the LED(b) illuminates continuously, and the machine is shut down.AØ HZVDIAGNOSTICSDIAGNOSENDIAGNOSTICOSDIAGNOSTICSRBaslerAUSAUSAPAGADOAPAGADOARRETARRETOFFOFFREMOTE STARTREMOTE STARTFERNSTARTFERNSTARTARRANQUE REMOTOARRANQUE REMOTODEMARRAGE ADEMARRAGE ADISTANCEDISTANCESTART / LAUFENSTART / LAUFENARRANQUE / MARCHAARRANQUE / MARCHADEMARRER / MARCHEDEMARRER / MARCHESTART / RUNSTART / RUNEMERGENCYSTOPAØ HZVRBaslerDIAGNOSTICSDIAGNOSENDIAGNOSTICOSDIAGNOSTICS042563wc_gr010359baVariable Normal Pre-Alarm Alarm To ResetFuel level >15% 15% 5% Fill fuel tank. Toggle start switch.Coolant temp 85°C±8 105°C 115°C Add coolant. Toggle start switch.Oil pressure 60–80 psi 20 psi 15 psi Add engine oil. Toggle start switch.Overspeed 60 Hz — 66 Hz Toggle start switch.Underspeed 60 Hz — 54 Hz Toggle start switch.Overcrank — — After 3 attempts Toggle start switch.Time to maintain 250 hours 0 hours — Reset genset controller.Coolant level Above sender — Below sender Add coolant. Toggle start switch.
