wc_tx003229gb_FM10.fm80Mobile GeneratorWorking with Basler Controller8.9 Changing the Units of MeasureRequirements Machine stopped Start switch in REMOTE STARTNote: Internal programming of the genset controller, or closed connections to aremote start switch, may cause the machine to start unexpectedly. Be prepared forthe engine to start even with the engine start switch in the REMOTE STARTposition.Background Genset controller units of measure may be set to English (imperial) or metric.Procedure Perform the procedure below to set the units of measure.1. Press the right arrow button (1) to access the MAIN MENU.2. Using the up/down arrow buttons (2, 3) highlight SETTINGS. Then, press theright arrow button.3. Highlight SYSTEM PARAMS. Then, press the right arrow button.4. Highlight SYSTEM SETTINGS. Then, press the right arrow button.5. Highlight the SYSTEM UNITS. Then, press the check mark button (5).6. If you are not logged in, enter the password “OP”. Press the check mark button.7. Using the up/down arrow buttons, change the value as desired. Press the checkmark button when finished.This procedure continues on the next page.
