Network Connectivity68 Xerox ® WorkCentre® 7800/7800i Series Color Multifunction PrinterSystem Administrator GuideConfiguring SNMPv3SNMPv3 is the current standard version of SNMP defined by the Internet Engineering Task Force (IETF).It provides three important security features:• Message integrity to ensure that a packet has not been tampered with in transit• Authentication to verify that the message is from a valid source• Encryption of packets to prevent unauthorized accessEditing SNMPv3 Properties1. In Xerox ® CentreWare ® Internet Services, click Properties > Connectivity > Setup.2. Under Protocol, next to SNMP, click Edit.3. Click Edit SNMPv3 Properties.4. To create the administrator account, under Administrator Account, select Account Enabled.5. Type and confirm the Authentication Password. The Authentication Password is used to generate akey used for authentication.6. Type and confirm the Privacy Password. The Privacy Password is used for encryption of SNMPv3data. The passphrase used to encrypt the data must match the passphrase on the Server.Note: Ensure that the passwords are at least eight characters in length. You can include anycharacters except control characters.7. To save the new password, click Select to save new password.8. Under Print Drivers/Remote Clients Account, click Account Enabled. To reset the default password,click Reset. This account allows Xerox ® clients and drivers limited access to objects on the printer.9. Click Save to apply the new settings or Undo to retain the previous settings.Configuring SNMP Advanced SettingsYou can add, edit, or delete IP and IPX addresses for Network Management workstations that receivetraps from the printer.Configuring SNMP Advanced Settings1. In Xerox ® CentreWare ® Internet Services, click Properties > Connectivity > Setup.2. Under Protocol, next to SNMP, click Edit.3. Click Advanced Settings.4. To add an IP trap destination address, under Trap Destination Addresses, click Add IP Address.5. To add an IPX trap destination address, under Trap Destination Addresses, click Add IPX Address.6. To edit an address, next to the address click Edit.7. To delete an address, select the check box next to the address and click Delete.
