10.2 List of Parameters10-510Appendix10.2 List of Parameters10.2.1 Utility FunctionsThe following list shows the available utility functions.Note: Execute the utility function with either a panel operator or SigmaWin+. If they are used together, "no_oP" or "NO-OP" will be displayed when the utility function is executed.∗1. This function can be used only with a SERVOPACK for analog voltage references.∗2. This function can be used only with a SERVOPACK for pulse train references.ParameterNo. Function ReferenceSectionComment: SigmaWin+function namesFn000 Alarm history display 7.2 Alarm DisplayFn002 JOG operation 7.3 JOG OperationFn003 Origin search 7.4 Origin SearchFn004 Program JOG operation 7.5 Program JOG OperationFn005 Initializing parameter settings 7.6 Editing ParametersFn006 Clearing alarm history 7.7 Alarm DisplayFn008 Absolute encoder multiturn reset and encoder alarm reset 5.9.4 Setting the Absolute EncoderFn009 *1 Automatic tuning of analog (speed, torque) reference offset 5.3.25.5.2 –Fn00A *1 Manual servo tuning of speed reference offset 5.3.2 –Fn00B *1 Manual servo tuning of torque reference offset 5.5.2 –Fn00C Offset adjustment of analog monitor output 7.8 Adjusting Analog MonitorOutputFn00D Gain adjustment of analog monitor output 7.9 Adjusting Analog MonitorOutputFn00E Automatic offset-signal adjustment of the motor currentdetection signal 7.10 Adjusting Motor CurrentDetection OffsetFn00F Manual offset-signal adjustment of the motor current detec-tion signal 7.11 Adjusting Motor CurrentDetection OffsetFn010 Write prohibited setting 7.12 Write Prohibited SettingFn011 Servomotor model display 7.13 Product InformationFn012 Software version display 7.14 Product InformationFn013 Multiturn limit value setting change when a multiturn limitdisagreement alarm occurs 5.9.7 Setting the Multi-Turn LimitFn01B Vibration detection level initialization 7.15 Initializing Vibration Detec-tion LevelFn01E Display of SERVOPACK and servomotor ID 7.16 Product InformationFn030 Software reset 7.17Resetting the SERVOPACKby Software or MECHA-TROLINK CommunicationResetFn200 Tuning-less levels setting 6.2.2 Editing ParametersFn201 Advanced autotuning 6.3.2 TuningFn202 *2 Advanced autotuning by reference 6.4.2 TuningFn203 One-parameter tuning 6.5.2 TuningFn204 Anti-resonance control adjustment function 6.6.2 TuningFn205 *2 Vibration suppression function 6.7.2 TuningFn206 EasyFFT 7.18 EasyFFTFn207 Online vibration monitor 7.19 Online Vibration Monitor
