2 Digital Operator2-22.1 Digital OperatorThe Digital Operator is a device that can be used to display SERVOPACK status, execute utility functions, setparameters, and monitor operation.2.2 Digital Operator ConnectionUse the external monitor connector (CN5) on the SERVOPACK to connect the digital operator. There are twoways to connect the digital operator. These are as follows:• Conventional connection• Connection with an analog monitor unit (If using this method, the digital operator and another device, suchas a monitoring device, can be connected to the SERVOPACK at the same time).The following table lists the devices and cables that are required for connection.The connection methods are shown below.2.3 Operation of Digital OperatorOperation examples of utility functions (Fn), parameters (Pn) and monitor displays (Un)when using a digital operator are described in this chapter.Operations can be also performed with SigmaWin+.For more information on the usage of the digital operator, refer toΣ-V Series User’s Manual Operation of Dig-ital Operator (Manual No.: SIEP S800000 55).Connection Method Required Devices and CablesConventional • Digital operator relay cable (model: JZSP-CF1S00-A3-E)• Digital operator (model: JUSP-OP05A-1-E)With an Analog Monitor Unit• Analog monitor unit connection cable (model: JZSP-CF1S05-A3-E)• Analog monitor unit (model: JUSP-PC001-E)• Digital operator (model: JUSP-OP05A-1-E)DigitaloperatorRelay cablefor digitaloperator㨂㧯㧹㧼㧿㨂㧻㧺 㧯㧻㧵㧺 㨀㧳㧻㧺 4'( 㧯㧴㧭㧾㧳㧱#.#4/㧰㧭㨀㧭㧶㧻㧳5810㧿㧯㧾㧻㧸㧸 㧹㧻㧰㧱㧛㧿㧱㨀㧾㧱㧿㧱㨀5'4814'#& 94+6'5'481;#5-#9#&+)+6#.12'4#614㧶㨁㧿㧼г㧻㧼㧜㧡㧭г㧝г㧱DigitaloperatorConnection cablefor analog monitor unitAnalogmonitor unit㨂㧯㧹㧼㧿㨂㧻㧺 㧯㧻㧵㧺 㨀㧳㧻㧺 4'( 㧯㧴㧭㧾㧳㧱#.#4/㧰㧭㨀㧭㧶㧻㧳5810㧿㧯㧾㧻㧸㧸 㧹㧻㧰㧱㧛㧿㧱㨀㧾㧱㧿㧱㨀5'4814'#& 94+6'5'481;#5-#9#&+)+6#.12'4#614㧶㨁㧿㧼г㧻㧼㧜㧡㧭г㧝г㧱Analog
