YASKAWA SI-EP3/V Technical Manual

Also see for SI-EP3/V: Installation manual

Contents

9 Web InterfaceYASKAWA SIEP YEACOM 06 V1000 Option PROFINET SI-EP3/V Technical Manual 46 Security LoginEnter a valid password and click “Log in”. The button text will change to “Log out” and the status will change to “Loggedin”.Note: The default security password is “yaskawa”.This password can be changed in the “Change Password” section of the tab. Entering a valid password allows access tothe settings in the Configuration tab, Email Alerts tab, and the Parameter Access tab. Change PasswordTo change the password, enter the new password in the “New Password:” and “Confirm Password:” text boxes then click“Change password”. The Status display will change to “Idle” then “Changing Password” then “Password Changed”. Ifthe passwords in the two text boxes do not match, the Status will display “Passwords don’t match”. Option CardThe values displayed in the various tabs are refreshed at the rate defined in the “Applet Refresh Rate (ms)” text box. Entervalues in the range of 1000 ms to 65.535 seconds.Parameter Security can be enabled or disabled by clicking one of the radio buttons. When “Disabled” is selected, nopassword is necessary and all functions in the web pages will be available. When “Enabled” is selected, a valid passwordmust be entered to edit email settings and to write parameters. Email SettingsThe “Email Server IP” text box must contain the IP address of the email server. The subnet address is configured in driveparameters F7-05 through F7-08. The configured email alerts will use the server at this address when sending emails.Enter the email server port in the “Email Port” text box.The value in the “From’ Email Address” text box identifies the origin of the email alerts to the recipient.Click “Submit Email Parameters” to save the email settings to the option.Click “Save Configuration Parameters to Flash” to save the entered values from this tab into non-volatile memory. Thesevalues will then be remembered after cycling power. General SettingsClick “Save Options Card Parameters” to save the Applet Refresh Rate and the Parameter Security settings to the option.