Yaesu FT-897D Operating Manual

Also see for FT-897: Manual Brochure & specs Technical supplement Service manual Operating manual

Contents

Page 65FT-897D OPERATING MANUALPOWER -ON M ICROPROCESSOR R ESETPROCEDURESSome or all transceiver settings can be reset to their factory-default states using one of the following power-on routines: [V/M] + POWER on: Resets all memories and follow-ing menu settings to their factory-default values:Menu #06 (AM STEP), 33 (DCS CODE), 52 (FM STEP),56 (MEM TAG), 76 (RPT SHIFT), 82 (SSB STEP), and83 (TONE FREQ). [F] + POWER on: Resets all menu settings (except thefollowing menu items) to their factory-default values.Menu #06 (AM STEP), 33 (DCS CODE), 52 (FM STEP),56 (MEM TAG), 76 (RPT SHIFT), 82 (SSB STEP), and83 (TONE FREQ). [HOME] + POWER on: CPU master reset for all memo-ries and menu settings.CLONINGYou can transfer all data stored in one transceiver to anotherset by utilizing the handy “Cloning” feature. This requires auser-constructed cloning cable which connects the CAT/LINEAR jacks on the two transceivers, as shown below.TX D TX DRX DGND GNDRX DTo clone from one transceiver to another, use the followingprocedure:1. Insert the Clone Cable into the CAT/LINEAR jack ofeach transceiver.2. Turn both transceivers off, then press and hold in theMODE() and MODE() but-tons on each radio while turningthe power on again. The “CLONEMODE” notation will appear onthe display.3. On the “destination” radio, pressthe [A] key.4. Now, on the “source” radio, pressthe [C] key. Data will now betransferred to the “Destination”radio from the “Source” radio.5. If there is a problem during thecloning process, “Error” will bedisplayed.Check your cable connectionsand try again.6. If cloning is successful, turn the“destination” radio off. Now turnthe “source” radio off.7. Remove the clone cable. Channel and operating data forboth radios are now identical. They both may be turnedon now for normal operation.[Sourcu radio][Distination radio]POWER-ON MICROPROCESSOR RESET PROCEDURES / CLONING