19 EnConnecting to networkPREPARATION EnglishBefore performing the following procedure, check thesecurity method and security key on the wireless router(access point).1 Press A to turn on this unit.2 Press SETUP.3 Use the cursor keys (B / C) to select“Network ” and press ENTER.yTo return to the previous state, press RETURN.4 Use the cursor keys (B / C) to select“Connection” and press ENTER.5 Use the cursor keys (B / C) to select“Wireless” and press ENTER.6 Use the cursor keys (B / C) to select “ManualSetting” and press ENTER.7 Use the cursor keys (B / C) to select “SSID”and press ENTER.8 Use the cursor keys to enter the SSID on thewireless router (access point), and pressRETURN to previous state.Use the cursor keys (D/E) to move the edit positionand the cursor keys (B/C) to select a character.9 Use the cursor keys (B / C) to select“Security” and press ENTER.10 Use the cursor keys (D / E) to select desiredsecurity method and press RETURN.SettingsNone, WEP, WPA2-PSK (AES), Mixed ModeIf you select “None”, the connection may be insecure since thecommunication is not encrypted.11 Use the cursor keys (B / C) to select“Security Key” and press ENTER.12 Use the cursor keys to enter the security keyon the wireless router (access point), andpress RETURN to previous state.Use the cursor keys (D/E) to move the edit positionand the cursor keys (B/C) to select a character.You can insert / delete a character, by pressingPRESET i (insert) or PRESET j (delete).13 Use the cursor keys (B / C) to select“Connect[ENTER]” and press ENTER to savethe setting.If “ERROR” appears, check the SSID and securitykey on the wireless router (access point) and repeatfrom Step 7.If “ERROR” not appears, a connection is success.Verify whether the unit is connected to a wirelessnetwork (p. 21).14 To exit from the menu, press SETUP.Set the wireless networkconnection manuallyPRESETMEMORYSETUPHOMEMUTENOW PLAYINGVOLUMERETURNENTEROPTIONRETURNSETUPENTERCursor keysB / C / D / ESSIDMANUALSSIDNoteWPA2-PSK(AES)SECURITYKEY