49 EnEnglishADVANCEDOPERATIONConfigure the system settings of the unit while viewing the front display.1 Turn off the unit.2 While holding down RETURN on the frontpanel, press A (power).3 Rotate SELECT/ENTER to select an item.4 Press SELECT/ENTER to select a setting.5 Press A (power) to set the unit to turn off andturn it on again.The new settings take effect.Change the unit’s speaker impedance settings dependingon the impedance of the speakers connected.SettingsWhen using multiple receivers in the same room, settingthe remote control ID of this unit to ID1 (and setting theanother receiver to other than ID1) can preventinterference from other remote controls.SettingsID1, AUTO (default)Restores the default settings for the unit.SettingsConfiguring the system settings (ADVANCED SETUP menu)ADVANCED SETUP menu itemsItem Function PageSP IMP. Changes the speaker impedancesetting. 49REMOTE ID Selects the unit’s remote control ID. 49TU Changes the FM/AM tuning frequencysetting. 49INIT Restores the default settings. 50UPDATE Updates the firmware. 50VERSION Checks the version of firmwarecurrently installed on the unit. 50VOLUMEPURE DIRECTRETURNCONNECTPUSH - ENTERTUNINGPRESETBANDMEMORY CLEARBASSINPUT5V 1ABALANCEL RTREBLE LOUDNESSFLAT-30dBDIMMER MODEDISPLAYSELECTPHONES SPEAKERSA BA (power)SELECT/ENTERRETURNDISPLAYChanging the speaker impedancesetting (SP IMP.)4 MINSelect this option when you connect speakers withan impedance of 4 ohms to less than 8 ohms to theunit.8 MIN(Default)Select this option when you connect speakers withan impedance of 8 ohms or more to the unit.Selecting the remote control ID(REMOTE ID)Changing the FM/AM tuningfrequency setting (TU)FM100/AM10Select this when you want to adjust the FMfrequency by 100-kHz steps and AM by 10-kHzsteps.FM50/AM9(default)Select this when you want to adjust the FMfrequency by 50-kHz steps and AM by 9-kHz steps.SP IMP.••8¬MINREMOTE ID•AUTOTU••••FM50/AM9