Zanussi ZCG 8021 Owner's Manual

INSTALLATION1. PARTS REQUIREDThe loose hotplate parts are packed in the polystyrene fitment on top of the hotplate.2. LEVELLING THE APPLIANCEIf the appliance requires levelling or its height adjusting (from the hotplate to any working surface), theprocedure below must be followed:1. Adjustment to suit floor conditions or height is obtained by rotating clockwise or anticlockwise the feet, atthe front and rear of the appliance.2. A spirit level should be placed on one of the oven shelves to confirm the appliance is correctly levelled.3. FITTING THE STABILITY BRACKETIt is recommended that if the appliance is to be installed with a flexible supply pipe a stability bracket(SK.4729.A) is fitted and is available from your supplier (see Important Safety Requirements,). Theseinstructions should be read in conjunction with the leaflet packed with the stability bracket.1. Place the appliance in its intended position and level appliance.2. Mark off 300mm from the left hand side of the appliance as shown in dimension 'A', Fig 2a. This is thecentre line of the fixing bracket.3. Draw a line 100mm from the front edge of the levelling feet (see Fig.2a) and remove appliance from itsposition. Mark off dimension 'B' (see Fig.2a) back from this line on the centre line of the bracket to locatethe front edge of the lower bracket. Fix lower bracket (with two fixing holes) to the floor then measure theheight from floor level to engagement edge on back of appliance, dimension 'C' of Fig.2b.4. Assemble upper bracket to lower bracket so that underside of bracket is dimension 'C' +3mm above floorlevel.Reposition appliance and check that top bracket engages into appliance back as shown in Fig. 2b.Fig.2a Fig.2b45100mm487mm (B)(A)300mm(C)