Zanussi ZCG 8021 Owner's Manual

If the wiring is extended or a completely new cable fitted a3-pin 13 amp plug should be fitted. (See Fig.4a). Connect thewires as follows:BROWN to the Live Terminal.BLUE to the Neutral Terminal.GREEN and YELLOW to the Earth Terminal.As the colours of the wires in the mains lead which you fitmay not correspond with the coloured markings identifying theterminals in your plug, proceed as follows:The wire which is GREEN and YELLOW must be connectedto the terminal in the plug which is marked with the letter 'E' orby the earth symbol or coloured GREEN or GREEN andYELLOW.The wire which is coloured BLUE must be connected to theterminal which is marked with the letter 'N' or colouredBLACK.The wire which is coloured BROWN must be connected to the terminal which is marked with the letter 'L' orcoloured RED.FIT A 3 AMP FUSE TO THE PLUG HOLDER.Ensure that the supply cable cannot get caught by the stability bracket. Plug in the appliance.6. PRESSURE TESTING1 The oven injector is used as a pressure test point.Remove the oven furniture. Remove oven burner box retaining clips (one spring clip from each side) andremove box front cover. Replace one clip back into the right hand side of the burner box.Remove oven burner by removing the spring clip from the right hand side of the oven burner and slideburner off injector whilst easing it forward and taking care not to strain the F.S.D. phial.2. Connect the pressure gauge to the oven injector.3. Check the supply pressure by turning the thermostat on and one hotplate tap full on and light theappropriate burner. The pressure should be either:-(i) For Natural Gas 20mbar(ii) For LP.GasThe pressure must be set to 28 mbar for use on butane or 37 mbar for use on propane.4. Turn off the taps, disconnect the pressure gauge and replace oven burner and cover, ensuring that theF.S.D. phial is correctly located into the bracket on the burner.5. Check operation of oven.7. CHECKING THE GRILLPlace the grill pan containing the grid, with the handle attached, into the grill compartment. Light the grillburner by turning the grill tap to its full on position and pushing the ignition button. As soon as the burner is litthe button can be released.8. CHECKING THE HOTPLATEFit the burner crowns and caps ensuring that they are correctly seated. Fit the pan supports. Check each ofthe hotplate burners in turn by turning the hotplate tap to it's full on position and pushing the ignition button.As soon as the burners are lit the button can be released.47Fig.4a