1-10To do… Use the command… RemarksCreate a Martini MPLS L2VPNconnectionmpls l2vc destination vcid[ tunnel-policytunnel-policy-name ][ control-word |no-control-word ]RequiredReturn to system view quit —mpls ldp remote-peerremote-peer-name RequiredConfigure the remote peerremote-ip ip-address RequiredFor remote peer configuration information, refer to MPLS Basics Configuration in the MPLS Volume.For a Martini connection, there are two main parameters: one is the IP address of the peer PE, the otheris the VC ID. The combination of the VC ID and the encapsulation type must be unique on a PE.Changing the encapsulation type may result in VC ID conflicts.Configuring Kompella MPLS L2VPNKompella MPLS L2VPN uses extended BGP as the signaling protocol to transfer L2VPN informationbetween PEs.To create a Kompella local connection, you only need to configure the VPN and CE connection on thePE. Neither IGP nor BGP L2VPN capability is required.Configuration PrerequisitesBefore configuring Kompella MPLS L2VPN, complete these tasks:z Configuring IGP on the PEs and P devices to guarantee the IP connectivity of the MPLS backbonez Configuring MPLS basic capability and MPLS LDP for the MPLS backbone on the PEs and Pdevices to establish LDP LSPsz Enabling MPLS L2VPN on the PEsTo configure Kompella MPLS L2VPN, you need the following data:z AS numbers of the local PE and the peer PEz Name, RD, and VPN Target attributes of the L2VPN connectionz CE name, CE ID, and CE rangez CE offset
