1-3To do… Use the command… RemarksEnter system view system-view —Manually restart the SMB slave restart RequiredAfter the SMB has restarted, the AMB will perform initial synchronization on the SMB. During thisprocess, the system does not respond to your input. After the initial synchronization is completed, youcan execute all the configuration commands on the AMB and the AMB and SMB will keep a real-timesynchronization process, meaning your configuration on the AMB will be copied to the SMB to ensurethe consistency of the current configuration of the AMB and SMB.Manually Configuring Switchover Between the AMB and SMBTo do… Use the command… RemarksEnter system view system-view —Enable the manual switchoverbetween the AMB and SMBslave switchover { disable |enable }OptionalEnabled by defaultManually configure switchoverbetween the AMB and SMB slave switchover RequiredThe original AMB will be restarted if an AMB and SMB switchover is performed. Therefore, ensure theconsistency of the software version of the AMB and SMB before performing an AMB and SMBswitchover. By default, if the versions of the AMB and SMB are not consistent, the original AMB cannotbe restarted; to perform an AMB and SMB switchover in case that their versions are not consistent,configure to ignore version check of the SMB.Displaying and Maintaining Dual-SRPU SystemTo do… Use the command… RemarksDisplay the switchover state(independent mode)display switchover state[ slot slot-number ]Display the switchover state(IRF mode)display switchover state[ chassis chassis-number slotslot-number ]Available in any view
