1-9Configuring an FTP TestAn FTP test is mainly used to test the connection between the NQA client and a specified FTP serverand the time necessary for the FTP client to transfer a file to or download a file from the FTP server.Configuration prerequisitesBefore an FTP test, you need to perform some configurations on the FTP server. For example, youneed to configure the username and password used to log onto the FTP server. For the FTP serverconfiguration, refer to File System Management Configuration in the System Volume.Configuring an FTP testFollow these steps to configure an FTP test:To do… Use the command… RemarksEnter system view system-view —Enter NQA test group view nqa entry admin-nameoperation-tag —Configure the test type as FTPand enter test type view type ftp RequiredConfigure the destinationaddress for a test operation destination ip ip-addressRequiredBy default, no destination IPaddress is configured for a testoperation.The destination IP address for atest operation is the IP address ofthe FTP server.Configure the source IPaddress of a probe request source ip ip-addressRequiredBy default, no source IP addressis specified.The source IP address must bethat of an interface on the deviceand the interface must be up.Otherwise, the test will fail.Configure the operation type operation { get | put }OptionalBy default, the operation type forthe FTP is get, that is, obtainingfiles from the FTP server.Configure a login username username nameRequiredBy default, no login username isconfigured.Configure a login password password passwordRequiredBy default, no login password isconfigured.Specify a file to be transferredbetween the FTP server andthe FTP clientfilename file-name RequiredBy default, no file is specified.Configure common optionalparametersRefer to Configuring OptionalParameters Common to anNQA Test GroupOptional
