1-8The remote source mirroring group on the source device and the remote destination mirroring group onthe destination device must use the same remote probe VLAN.Configuring a Remote Source Mirroring Group (on the Source Device)To configure a remote source mirroring group, make the following configurations on the source device:Creating a remote source mirroring groupFollow these steps to create a remote source mirroring group:To do… Use the command… RemarksEnter system view system-view —Create a remote sourcemirroring groupmirroring-group group-idremote-sourceRequiredBy default, no mirroringgroup exists on a device.Configuring mirroring ports for the remote source mirroring groupYou can configure a list of mirroring ports for a mirroring group at a time in system view, or assign onlythe current port to it as a mirroring port in interface view. To assign multiple ports to the mirroring groupas mirroring ports in interface view, repeat the step.z Configuring mirroring ports in system viewFollow these steps to configure mirroring ports for the remote source mirroring group in system view:To do… Use the command… RemarksEnter system view system-view —Configure mirroring ports forthe remote source mirroringgroupmirroring-group group-idmirroring-portmirroring-port-list { both |inbound | outbound }RequiredBy default, no mirroring port isconfigured for a mirroringgroup.z Configuring a mirroring port in interface viewFollow these steps to configure a mirroring port for the remote source mirroring group in interface view:To do… Use the command… RemarksEnter system view system-view —Enter interface view interface interface-typeinterface-number —Configure the current port as amirroring port[ mirroring-group group-id ]mirroring-port { both |inbound | outbound }RequiredBy default, a port does notserve as a mirroring port for anymirroring group.
