3Com® VCX V7111 VoIP Gateway User Guide 157ini File Parameter Name Valid Range and DescriptionSerial parameters (applicable only to the VM SMDI application)SerialBaudRate Determines the value of the RS-232 baud rate.The valid range is: any value.It is recommended to use the following standard values:1200, 2400, 9600 (default), 14400, 19200, 38400, 57600, 115200.SerialData Determines the value of the RS-232 data bit.7 = 7-bit.8 = 8-bit (default).SerialParity Determines the value of the RS-232 polarity.0 = None (default).1 = Odd.2 = Even.SerialStop Determines the value of the RS-232 stop bit.1 = 1-bit (default).2 = 2-bit.SerialFlowControl Determines the value of the RS-232 flow control.0 = None (default).1 = Hardware.Advanced ConfigurationUse this menu to set the gateways advanced configuration parameters.Those parameters contained within square brackets are the names used to configurethe parameters using the ini file.Configuring the Network SettingsFrom the Network Settings you can: Configure the IP Settings (see Configuring the IP Settings). Configure the Application Settings (see Configuring the Application Settings). Configure the NFS Settings (see Configuring the NFS Settings). Configure the IP Routing Table (see Configuring the IP Routing Table). Configure the VLAN Settings (see Configuring the VLAN Settings). Configure the PPPoE Settings (see Network Settings ini File Parameters).Configuring the IP SettingsTo configure the IP Settings parameters:1 Open the IP Settings screen (Advanced Configuration menu > Network Settings > IPSettings option); the IP Settings screen is displayed.
