Actual signals and parameters 145Parameters in the short parameter viewParameters in the short parameter viewNo. Name/Value Description Default11 REFERENCESELECT Panel reference type, external control location selectionand external reference sources and limits. See Group11: Reference select in the list of all parameters.1105 REF1 MAX Defines the maximum value for external referenceREF1.E: 50.0 HzU: 60.0 Hz12 CONSTANTSPEEDS Constant speed (drive output frequency) selection andvalues. See Group 12: Constant speeds in the list of allparameters.1202 CONSTSPEED 1Defines constant drive output frequency 1. E: 5.0 HzU: 6.0 Hz1203 CONSTSPEED 2Defines constant drive output frequency 2. E: 10.0 HzU: 12.0 Hz1204 CONSTSPEED 3Defines constant drive output frequency 3. E: 15.0 HzU: 18.0 Hz13 ANALOG INPUTS Analog input signal processing. See Group 13:Analogue inputs in the list of all parameters.1301 MINIMUM AI1 Defines the minimum %-value that corresponds tominimum mA/(V) signal for analog input AI1.1.0%14 RELAY OUTPUTS Status information indicated through relay output, andrelay operating delays. See Group 14: Relay outputs inthe list of all parameters.1401 RELAYOUTPUT 1Selects a drive status indicated through relay outputRO 1.FAULT(-1)16 SYSTEMCONTROLSParameter view, Run Enable, parameter lock etc. SeeGroup 16: System controls in the list of all parameters.1611 PARAMETERVIEWSelects the parameter view, in other words, whichparameters are shown on the control panel.SHORTVIEW20 LIMITS Drive operation limits. See Group 20: Limits in the list ofall parameters.2008 MAXIMUMFREQDefines the maximum limit for the drive outputfrequency.E: 50.0 HzU: 60.0 Hz21 START/STOP Start and stop modes of the motor. See Group 21:Start/Stop in the list of all parameters.2102 STOPFUNCTIONSelects the motor stop function. COAST22 ACCEL/DECEL Acceleration and deceleration times. See Group 22:Accel/Decel in the list of all parameters.2202 ACCELERTIME 1Defines the acceleration time 1. 5.0 s2203 DECELERTIME 1 Defines the deceleration time 1. 5.0 s
