Fieldbus control 319a.Points not listed are not used in this application.b.A single value in a column means that the value is the same in English units and in SI units.c.Point numbers that appear in brackets { } may be unbundled at the field panel. Detailed point descriptions{94} LDO RESET FAULT NO - 1 0 RESET NO{95} LAO MBOX PARAM - - 1 0 - -{96} LAO MBOX DATA - - 1 0 - -{97} LDO MBOX READ DONE - 1 0 READ DONE{98} LDO MBOX WRITE DONE - 1 0 WRITE DONE{99} LAO ERRORSTATUS- - 1 0 - -FLN Detailed Point DescriptionsPoint Description DriveParameter1 CTRLADDRESSThe FLN address of the drive. It can be set by FLN andby the panel.53022 APPLICATION The Application ID for FLN on the ACS320. This ID isassigned by Siemens for each unique application. Itcorrelates directly to a particular point list approved atthe time of release. Therefore, this point list shall remainfixed once approval is granted. Any changes to the pointlist shall require a new Application ID and re-approval bySiemens. The Application ID assigned to ACS320 is2934.3 FREQ OUTPUT The output frequency applied to the motor, in Hertz. 01034 PCT OUTPUT The ratio of output frequency or speed to thecorresponding maximum rating, depending on controlmode.For scalar mode, it is the ratio of Output Frequency(parameter 0103) to Maximum Frequency (parameter2008).None. Thisratio iscalculatedby the FLNapplication.5 SPEED The calculated speed of the motor, in RPM. 01026 CURRENT The measured output current. 01047 TORQUE The calculated output torque of the motor as apercentage of nominal torque.01058 POWER The measured output power in KW. The FLN pointdefinition also supports horsepower by selecting Englishunits.01069 DRIVE TEMP The measured heatsink temperature, in ° C. The FLNpoint definition also supports ° F by selecting Englishunits.011010 DRIVE KWH The drive's cumulative power consumption in kilowatt-hours. This value may be reset by commanding FLNpoint 49, RESET KWH.0115FLN Point DatabasePoint Subpoint NameFactoryDefault Engr.Units Slope Intercept On Text Off Text# Type (SI Units)
