Actual signals and parameters 159 Group 04: Fault historyThis group stores a recent history of the faults reported by the drive.Group 04: Fault historyCode Description Range Resolution Default S0401 LAST FAULT Fault code text 1 00 = Clear the fault history (on panel = NO RECORD).n = Fault code of the last recorded fault.• The fault code is displayed as a name. See chapter Fault tracing on page 359 forthe fault codes and names. The fault name shown for this parameter may be shorterthan the corresponding name in the fault listing, which shows the names as they areshown in the fault display.0402 FAULT TIME 1 Date dd.mm.yy /power-on days1 0The day on which the last fault occurred. Either as:• A date – if real time clock is operating.• The number of days after power on – if real time clock is not used, or was not set.0403 FAULT TIME 2 Time hh:mm:ss 2 s 0The time at which the last fault occurred. Either as:• Real time, in format hh:mm:ss – if real time clock is operating.• The time since power on (less the whole days reported in parameter 0402 FAULTTIME 1), in format hh:mm:ss – if real time clock is not used, or was not set.Format on the basic control panel: Time elapsed after power-on in 2-second ticks(minus the whole days stated by signal 0402 FAULT TIME 1). 30 ticks = 60 seconds.For example, value 514 equals 17 minutes and 8 seconds (= 514/30).0404 SPEED AT FLT - 1 rpm 0The motor speed (rpm) at the time the last fault occurred.0405 FREQ AT FLT - 0.1 Hz 0.0The frequency (Hz) at the time the last fault occurred.0406 VOLTAGE AT FLT - 0.1 V 0.0The DC bus voltage (V) at the time the last fault occurred.0407 CURRENT AT FLT - 0.1 A 0.0The motor current (A) at the time the last fault occurred.0408 TORQUE AT FLT - 0.1% 0.0The motor torque (%) at the time the last fault occurred.0409 Reserved for future use0412 PREVIOUS FAULT 1 Fault code text 1 0Fault code of the second last fault. Read-only0413 PREVIOUS FAULT 2 Fault code text 1 0Fault code of the third last fault. Read-only.0414 DI 1-5 AT FLTStatus of digital inputs DI1...5 at the time the latest fault occurred (binary).Example: 10000 = DI1 is on, DI2...DI5 are off.