5-78container CommandsParameters{container}Specifies the ID number (0 to 63) of the array you want toreconfigure.{scsi_device}...Specifies one or more devices. Typically, you specify one ormore devices when adding more drives to an array or movingan array’s partitions. A SCSI ID consists of a SCSI channelnumber (for example, 0, 1, 2, 3, etc.), a SCSI device ID (0through 15 inclusive), and a SCSI device logical unit number (0through 7 inclusive). See the scsi_device section onpage 3-7 for more information on how to specify the SCSIdevice. The command uses the freespace(s) from the SCSIdevice(s) you specify to reconfigure the array.Switches/stripe_size{=integer}Specifies the changed stripe size for the array. You can specifystripe sizes for the following types of arrays: RAID-5 set Multilevel stripe set:– Stripe set of mirror sets– Stripe set of volume sets– Stripe set of stripe sets/extend_fs{=boolean}Specifies whether to extend the file system so that it occupiesthe entire reconfigured array. If you specify TRUE, thecommand adds no new freespace and extends the file systemso that it occupies the entire reconfigured array. (The commandextends the file system after completing the reconfigureoperation.) If you specify FALSE, the command adds freespaceto the reconfigured array and does not extend the file system tooccupy the entire reconfigured array.This switch defaults to FALSE.
